Skip to content
English - United Kingdom
  • There are no suggestions because the search field is empty.

Replace Nullifire FJ220 Slab Edge After Water Exposure

Summary This article explains how moisture exposure affects the Nullifire FJ220 slab edge system and the resulting recommended action when the system has been exposed to water.

How moisture exposure affects FJ220

  • If the FJ220 system has been exposed to water or become saturated, its properties may have been affected.
  • Because water exposure can effect the product’s properties, any FJ220 that has been exposed or saturated should be replaced.

Recommended action after water ingress

  1. Carry out a site assessment to identify areas where FJ220 has been exposed to water.
  2. Treat any area where the FJ220 has been exposed or is saturated as requiring replacement, even if no obvious visual damage is present.
  3. Replace the affected sections of the FJ220 system with new material.

Troubleshooting and inspection notes

  • Visual assessment alone may not reveal changes to product properties caused by water saturation; replacement is recommended where exposure or saturation has occurred.
  • Use replacement rather than attempting to rely on the original material where water contact has occurred.

Conclusion Any FJ220 slab edge system exposed to water or found to be saturated should be replaced, because this can effect the product’s performance in service.